Hey all! Hope the week is well!! Just showing some stuff here. These are the KATO Montana Rail Link SD70Ace #4400 #4401. I have a few sets of...
I saw on the internet that Kato sells flex track. Does anyone have any experience with this stuff? My last layout went away during our last move...
I plan to use these on my track, Kato's Wooden Engine shed. https://www.amazon.co.uk/Kato-23-225-Wooden-Engine-Shed/dp/B002OBA6UC And I am...
So I messed up, I tried to run my HO Hayabusa on a Hornby system. Worked great for a little while before the motors burnt out completely. All 4. I...
I've been thinking of adding lights to my Kato N scale Daylight set. From what I've read any kit involving bulbs is a no go due to the heat. Of...
My dad requested I change the couplers on 3 of his Kato SD70Ace's from Kato's to Micro Trains 2004's. It was easy enough to remove the coupler...
I need to know what DCC system I should purchase to get started. I've built a tabletop for an L-shaped layout along two walls measuring 15' and...
I've installed a Kato FL12 in each end of my Kato ICE 4 and an EM13 in the center-powered car. Unfortunately, the FL12s seem impossible to...
Does Kato make an N Scale Unitrack low level platform to fit between two tracks with a No. 6 switch at each end, as in a passing siding?...
Is there an electronic circuit or component that can convert the 3 wire white/yellow/blue from a DCC decoder into a 2 wire bipolar output? I have...
Have made a cursory search for this informaton on the board, so if someone has already found the source, just respond with the link. I'm getting...
Hoping someone can help me out here. I have Kato HO #6 electric turnouts ( left and right turnouts) and none of them have screw settings to make...
I dont have a ton of space but I designed a layout and needed some feedback. N scale Coal and intermodal layout designed to have some small yard...
Kato specifies 9 3/4" as their standard test or development radius for their N scale models, unless mentioned otherwise in the description of...
I hope I didn't miss an obvious post, but after all this time are there still no generic connectors that fit the Kato power plugs exactly (no need...
Good morning! I am looking for decals to change the road numbers for these eight Kato Union Pacific BethGon Coalporters. Which decal set would be...
Author: scottakoltz [IMG] Prototype History - From Amtrak to Metra The EMD F40PH is a four-axle, 3,000 - 3,200 horsepower locomotive built during...
Hi all, I acquired a Kato TGV Sud-Est(10-198). It's missing the Pantographs. My manual shows the pantograph part # S14701F. Does anyone know...
I posted a general overview of Shinkansen trains in Japan in the general "The Ready Track" forum. Here I will post about N-scale models. Japan...