A real pain to install. Very small clearance from side of motor housing to inside of shell. Mount as low as you can, bottom of shell's edge. They...
Side emitting Amber LEDs CA'd to the side of the plastic motor housing. It will JUST clear the side of the shell when it is on. Use magnet wire...
mount a large LED at the middle of a piece of styrene. Mount an SMD resistor here or wire one in back near the motor contacts because there is no...
Lenz Silver Mini, Digitrax DZ125 or CT Elektronik are the only ones that will fit under the cab roof. CT Elektronik is the smallest but will have...
At the bottom, 240Vac (nominal) to 15Vac (nominal), 10A total (150W?) Atop that, NCE Power Pro, command station and 5A booster, dialled for...
Shelving and Framing where wiring (and layout) will go. Close up of the home of the electrics - transformer, DCC command station, throttles, mains...
Overhead wires and a blue rail, using an AR to make it all Just Work Magically.
2nd car has 8 pin standard N Scale NMRA connector w/ Digitrax DZ123PS installed.
These are my collection of GP60s so far all lined up on my work bench. The two units on the test track has newly installed mini sheer brilliance...
