I need a link to a site that offers us downloadable building in z scale to print and cut out for our layout. Does anyone know of any sites? Houses...
Thanks very much for the info. I'm adding a pick of my marklin track but want to do the figure 8 or something in the middle. This will give me two...
This is just the info I needed. I want to put a small figure 8 in the middle of my tracks. Is it best to use flex track to make a curved section....
PRINTABLE TRAIN STUFF NEEDED I need to find printable retaining walls for G scale. Does anyone know a site that allow printable stuff? Thanks Ron
Do they make digital Z locomotives with factory sound? Is there a place to buy Z track packages for layouts on the internet like the store that...
Maybe I should rephrase this a little. I want to add another loco to my track which is small and DCC run. I like steam and I have a N scale...
I am working with steam and wondered if any new N locos have come out in steam with factory DCC and Factory sound. I'm out of the loop for knowing...
Thanks for the tips and picks I love rats with flat tails and the cattail tip. Ron
Any good videos showing how to build a nice pond. Thought maybe you pros could point me in the right direction. I have some of my water area cut...
Thanks for all your suggestions. Think DC locos will be used on insulated tracks only. Ron
I have a total DCC Layout in N scale. Can non DCC Locos be left on the tracks while you run the DCC locos? Will Non DCC locos be hurt by this?...
I ordered PizzaLand which is a building used in the Soprano's episodes. Does anyone know if any other Soprano's buildings being produced? How...
I think you are saying remove the light board and basically wire the 750 into the wires on the female plug. I guess if I were to wire the 750 to...
That does sound good. I see where you want the Tsunami wired into the plug. Usually Spectrum gives a wire code for their tenders. I gotta check...
Opened it again but to me it looks like the tender is too tiny. Can't fit the cap and speaker in either. Maybe the larger tender...
I did look but thought since I forgot I'd ask. Will try to pull it apart later. Ron
Where is the plug your talking about? Is the Vandy tender big enough for the tsunami? Ron
ADDING SOUND TO A BACHMANN N SPECTRUM ARTICULATED STEAM LOCO WITH VANDY VC12 TENDER Can anyone reccomend the procedure to use? It has factory...
Don't like the factory scuff setting sound. How can I change the sound to have more scuffing hiss like real steam. Working with the Digitrax...
Thanks for all the comments! Really helps that I don't like heights. I drive the loco gingerly around the curve and straight of the trestle...