Previously I made wall sections like what is on this page but they were …. …. wall sections that were suppose to represent blocks of cut stone. One of my early projects and they probably could be better and I might go back and revisit them but for now I wanted wall sections of brick with reinforced concrete caps and ends. I'm not going to go into how they are to be used as you can find that information ( HERE ) when I went through it with the block walls. You will find files on my thingiverse.com account ( HERE ) to print walls with the bricks on one side or both and I added that feature to the block walls ( HERE ). If the wall is an embankment wall where you only see one side print the 'one sided' walls. If the wall is going to be free standing, like a wall between two properties print the walls with bricks on both sides. The following pictures should give you a better feeling for the walls. As you can see above the bricks are really small compared to the blocks. After I posted the pictures above I realized I had the printer on 'Standard Quality' when I printed the brick walls not 'Super Quality' ( two steps better). Still the wall came out well. I'll have to reprint and post more pictures later. Here …. … is an example of the bricks painted ( HERE ). You can find the files to print the wall sections on my thingiverse.com account ( HERE ). You can find all the files to 3D print this object and others on my thingiverse.com account ( HERE ). I also have info on the brick wall on my web site here... http://1fatgmc.com/RailRoad/3D-Printer-2/page-46.html Sumner
