Hi, I'm using the ethernet port on my Lenz LI-USB-ETHERNET device to connect to JMRI and DecoderPro. I'm having an odd problem. The first line/CV that is either read or written always times out. It takes a few minutes to do "anything" because the first one always times out, for instance when I read a page, the first item will time out then the rest of the page reads just fine. It's always only the first item/CV that's read or written and everything else after that always works fine. I'd appreciate any suggestions because I have no clue what to adjust or where to look. I'm using the default IP address of 192.168.0.200 on the device and I can run throttles and turn the layout on/off with no problems. Thanks, --Jason
Are you sure power is turned on. I have the same system sand do not have that problem, but really have not tried it recently. What happens if you only use the Lenz programmer and not JMRI?
