I debated whether to post this only on the N formum, but I thought that the rest of the DCCers could use the info. I've seen this decoder and it is tiny. about 2/3 the size of a penny. I don't get paid by Lenz for doing this but I 'm putting out here because it's so small. remember it's continuous draw is .5 amps so be careful. Lenz announces the world's smallest NMRA DCC decoder with exceptional performance of Load Compensation or "BACKEFM". Available March 2001. Features includerecision back EMF motor control for exceptionally smooth performance. Improved packet reception for superior dirty track operation. (100% packet reception for NMRA tests)Function control that retains its value across power interruptions.Ultra small micro design to fit into tight spaces (Smaller then the LE077XF)Supports all NMRA defined speed steps including both 128 and 255 speed step averaging control. Directional headlights can also be dimmed using an extra function Supports all forms of RP-9.2.3 service mode programming,Supports both RP-9.2.1 Long Form and Short Form Operational mode programming so that CVs can be reconfigured while the locomotive is operating on the main line. Factory installed nonlinear speed table for exceptional smooth performance and user selectable 14,28 or 128 user speed tables. Superior DC control and automatic DC/DCC conversion which can be disabled if desired. Automatic braking in DC mode can be configured even if DC automatic mode is disabled. Extended 4 digit addressing, advanced consisting and user selectable forward direction. Fully tested for full compliance to all NMRA and Industry defined Standards and RPs DCC Industry's most comprehensive "goof proof" warranty (no hidden charges) Size L 0.51" x W 0.36" x H 0.14" .5 amps continuous motor control
I have just ordered four of these to place in to the following Nscale engines. 2 x Atlas GP40 1 x Atlas GP7 1 x Kato SD40 (not -2) my question is Have you done a conversion with this decoder? if not has anybody else? I am open to any tricks or problems in placing the decoder in these engines.
Hi there, MRL Mick, We're going through a 'grand blizzard' here in NE USA so I'm sorry it's taken so long to get back to you. I've sent your post on to a friend who has had lots of experience. I hope she can help you.
