I hope I am posting this in the correct thread. If not, please feel free to move it to where it would belong. When soldering, and all the soldered materials are metal (and perhaps computer board ties, as in hand laying turnouts and crossings)...is there a way to move quicly over the soldered places with a portable soldering torch (like those used in plumbing) to help flatten and blend in those lumps of solder that accumulate. The only way I know to remove such is by filing. I am wondering if there is a better way, especially when the lumps are located on the rail near bottom? respectfully for all the expert soldering folks here (but then I suppose the experts may not end up with lumps!) Gary L Lake Dillensnyder
I use a paste flux that lets the solder flow easily. I am not doing turnouts, but I used if for soldering track together. Also make sure your parts are clean before you start. Clean the flux residue off the joint after you are done. Hope that helps.
I won't move this thread, but I will copy it to DCC and electronics forum. You will have to watch both places for answers.
