South skyboard.
East skyboard.
Closet Deck.
Melamine desktop of my new desk. 1/4" thick aluminum angle supports the front span.
Aluminum angle bolted to wall. I drilled countersunk holes to get the screws flush with the angle. I used #14 2 1/2" Spax screws.
Aluminum angle for support across the front of the desk. I used 1/4" thick 1" angle.
I drilled a 5/64" pilot hole in the 1/4" aluminum angle.
photo of my home N scale layout in New Zealand i'm running SP ,D&RGW & UP on a 5.0m x 6.0 layout.
photo of my home N scale layout in New Zealand i'm running SP ,D&RGW & UP on a 5.0m x 6.0 layout.
EH200 and EH500 at night layout near depot
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from below.
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from above.
