Shows wiring scheme for DS64 to Tortoise and seperate control panel
Using 8 conductor Cat5e wiring runs from DS64 to Tortoise. For local test module, turnout position reporting and frog power.
Wiring diagram turnout test module to DS64 and Tortoise.
Progress on the staging yard bungalow. One PM42 feeds one BDL168. I'll be adding another BDL168 in the future. Two DS64's are shown in the sliding...
Major layout electronics modules will be housed in the staging bungalow. Including PM42, BDL168, & DS64. There is room for another BDL168...
Major layout electronics modules will be housed in the staging bungalow. Including PM42, BDL168, & DS64. BDL168 is stacked on PM42.
Major layout electronics modules will be housed in the staging bungalow. Including PM42, BDL168, & DS64. A DS64 is shown in the mounting...
Major layout electronics modules will be housed in the staging bungalow. Including PM42, BDL168, & DS64.
I'm working on a scheme to utilize the PSXAR photcell inputs to stop a train at either end of a reversing section of track. This idea uses the...
I'm wiring these DS64's for easy panel wiring. Per my schematic: http://www.trainboard.com/railimages/showphoto.php/photo/99470/ppuser/7443
I use a 2.1mm jack wire to a terminal block to distribute power to DS 64 modular jacks.
DS64 #41 is setup with 2 RJ45 connectors to feed tortoise motors 41-44.
DS64s are mounted to a removable 1/4" hardwood board. The removable panel is fitted with handles to make it easier to remove.
DS64s are mounted to a removable 1/4" hardwood board. DS64 #41 (Far right) is setup with 2 RJ45 connectors to feed tortoise motors 41-44. A...