Just my 2 cents. I have a p2k sd-60m. It is MUCH slower than any of the atlas or athearn engines I have. Runs really well (slow speed and...
Does anyone make a pre-wired 8 pin harness? I've seen the sockets without wires attached but I'd like to save the effort of soldering wires to...
Anyone know where I can pick up a modern bottom dump grain trailer? I've looked many places and cant seem to find one. I e-mailed...
Probably been answered before but are the two compatible? If so are the ME turnouts worth consideration? I have had problems with my atlas c55...
In regards to the detail factor, it doesn't play much of a role for me either. The size of HO models is for some reason much more satisfying to...
Can't say for sure which line it is (CN I believe) still has a whole bunch of them in service. Always saw large numbers of spines on the north...
Yeah, I think N is the way to go. I've already got a Kato sd-40 and about 14 pieces of rolling stock. I have had some Atlas c55 set up in a...
Forgot to mention that when adding the width it would be on the inside. Instead of building the little corner braces it would just be square...
oddly enough every time I drive by one of those u-store-it places that thought pops into my head! Thanks for the suggestions. I do in fact...
Okay, new thread, sos. I can come up with the space to build this http://www.layoutdesignservice.com/lds/samples/betterbeginnerlayout.htm...
Does anyone make a 5 unit well car in N? All I have seen is 3 units. Or did I maybe see one from Walthers? Speaking of Walthers, is the...
Trainz is awesome....for a while. I still mess with it quite a bit but until someone comes out with a new sim that supports multiplayer its kind...