do the rare earth magnets work better than the kato ones? I have unitrack. my track is layed over foamcore board.... Would I embed the...
with several 2-3 sidings.. pictures
I really don't have much rolling stock...just a few cars to run while I put my layout together so I can really do "anything" then get the rolling...
what one industry would have several different buildings with several sidings....like two buildings or groups of buildings each with their own...
time fram is probably pretty modern given the dash engine.... I'd say 1980's to current times. I just can't decide on what industry / industries...
I am really stuck as to what industries to put over on the left.. looks like I could put in 2 small/medium industries.... suggestions.... help????
I've decided to get rid of the "track to nowhere, so I'll have to work on that bridge area....to make it look like the rest of the Canyon. I've...
think I want an f3 enigine santa fe dcc any thoughts....?
in diesel that is or can be dcc equiped that I can run???
running dcc using prodigy express is there a decoder that makes sound (diesel) that will work with this controller... I know nothing about sound
diesel set out there with a single engine with 4 axles and a few passenger cars out there to run on my smallish layout.....
I may attempt at making the water a bit like rapids..... not sure yet...I was originally going to put about 1/2" of "water" in the river....but...
there are a few little white spots that I noticed when photographed and a few areas where I need to blend in the burnt umber color..... The I...
Not sure of the water..... thinking about the new Magic Water product that I say on ebay..... I carved the rock/bed out of the foam core...
mp-15dc
still needs touch up....and its wet if a few spots, but I could resist taking a few pictures... as always comments appreciated: [img] [img]...
i need to make a river.....I need about 1/2 inch of water in it..... What is the best product to use.....? How do you make ripples in the water...
good point on the peanuts...... the foam is 1 1/2" and is cut from a 4 x 8 sheet of foamcore insulation that I got at Home Depot The track that...
OH..... I have to have a mountain/tunnel because really, what model railroad is complete without a tunnel. I am building the tunnel out of...
magnets are loose on my kato uncoupler track.... what should I glue them back in with....?? hot glue??? super glue??? please advise
