I have posted this on JMRI and have had no response. So will try here for a possible answer and solution. I am using a basic DCC++ setup with a Pololu Motor shield. The Sketch is basic with no changes from the latest download from Github. On my other DCC system (Lenz Set-100) I have several NCE Switch Kat accessory decoders, thet are number 1-4 and work as 1-4 on the Lenz system and also with JMRI. On the DCC++ system the numbers are different, have tried 2 so far and the #1 actives in JMRI as #5 and and #4 actives as #8 I think I under stand the numbering, but where can I fix it to be like the Lenz system? Can this changed in DCC++ sketch? Dennis
I guess know one wants to look at this. JMRI output T00x-T003x = nothing JMRI output T10x= turnout ID address #1 JMRI output T13x= turnout ID address #4 Should it actually start as T00x being turnout address #1 and T03x be turnout #4? Confused.