Valance frame
Closet Deck.
I'll use slotted steel angles to hold up the desk beneath the layout inside the closet. I chose 1 1/2" steel to provide enough support...
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from below.
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from above.
West side to the closet. This is the second attempt at cutting this piece. I cut this large, then trimmed the front to match up with the l-girders.
South gap. Cut plywood to fill south gap. Added some shims to get the front to back level.
I used four triangle brackets to provide permanant support for the valance. The brackets are bolted to the studs and valance.