With a 125Khz rfid one like this....
You should first test for a inverter short by powering on the power supply with Nothing hooked to the outputs. If this works without error then...
Locos respond to commands by turn the motor on and off, this is what the h-bridge is reading. Sometimes newer locos and decoders are more...
DCC++ is primarily a bus for the locos (has the ability to do some command control ). Locos only provide feedback during programming so the bus is...
The short answer is depending on your setup unhook the programing track pin (you may have to fold it over before plugging in the shield) and hook...
[ATTACH] Sensor 3 will show you which way the train is going. See if 1st sensor has been tripped within a set time then set sensor 2 to switch the...
If sensors are placed 3 inches or 8 cm from the points inside the loop (assuming the cuts are right at the points) and you already know which way...
Good job Erik84750, Your first problem is using the term auto-reverse this applies exclusively to a dc only system. In DCC you do not need a...
Cool project, a ATmega328P microCONTROLLER from a uno with DCC++ pre installed and a properly heatsinked h-bridge on the same board that plugs...
It's analogue if you look at the block diagram in section 2.1 of the infineon data sheet it shows a pic of a variable resistor on one end of the...
Somewhere in the source code for the base station you need to change the values for what a overcurrent event is. here it is. From...
I have been gone a long while but if memory serves there was a way to do it with JMRI. As for having a consist in dcc++ i dont remember that being...
All you have to do is put your call in the packet header and your good to go. (y)
Here is a list of the commands and how to use them in your menu you develop....
Those are 283 chips not 289 they will not be big enough (1.2a max) to run a train.
I looked in SerialCommand.cpp and the D command it still there. It is a capital D you have to send in the serial monitor window. Here is the usage...
I found this and thought it could be useful for anyone playing with the esp8266. https://leanpub.com/ESP8266_ESP32
l293 is only 1A 2A max z scale maybe. l293d is 600ma 1.2 a max. Is there a scale smaller than z?
A Raspberry Pi is not the same as a Arduino uno or mega. DCC++ is meant for Arduino Uno or Megs boards, you can use the Raspberry Pi to run JMRI...
I was going to use one of the ACS712T set for 10a - 15a as a short detector and use a separate 298p for programming, or a buch of acs712's as...
