Hi everyone! First a great Thank You all! I've searched different q&a in this forum since I started with the z-scale, and many of You have been...
Finished (altough there is still some things to change and improve)
Almost finished
I haven't been on here for a while so it's over due to show what I have been up to. I was at a Goodwill store and found a real nice glass top...
on a 5x9 table layout.
5/18/11, NS 9359 overboard into the turn table pit at MRL Laurel yard.
Z scale coffe table layouts (4) in the Hohenstaufen Hotel in Göppingen Germany, home of Märklin.
I replaced the Tortoise motor at the entry/exit turnout to LT Loop with an Atlas Twin coil machine. The snap coil works faster than the Tortoise...
for my Halland Yard transfer table. The printer cost $2.00. I'd like to use the print head shaft and motor. The print head is driven by a belt and...
Hole Cutout for Transfer Table. Used blue painters tape at both ends of the yard to create a bowl.
My 3rd attempt at a transfer table (left) compared to my 1st attempt (right). Still need smaller size & smoother operation
My 3rd attempt at a transfer table. Still need smaller size & smoother operation
The sled becomes misaligned every time I try to retract the table.
Top View - My first attempt at making an operating transfer table. The table will be installed at the end of my A/D track, and will move power...
Front View - My first attempt at making an operating transfer table. The table will be installed at the end of my A/D track, and will move...
Bottom View - My first attempt at making an operating transfer table. The table will be installed at the end of my A/D track, and will move...
Two 2.5 x 2 ft panels for layout can be stowed using four legs when layout is not in use.
