molex

Thread

I hope I didn't miss an obvious post, but after all this time are there still no generic connectors that fit the Kato power plugs exactly (no need...

Thread by: FlightRisk, Aug 3, 2020, 6 replies, in forum: N Scale

Media

Molex .093" & .062" series connectors.

Uploaded by: gregamer, Feb 8, 2009, 0 comments, in category: RailImages Member Galleries

Media

Mounted on a four position decora style light switch cover. The PM42 is affixed to a 1/4" hardwood strip that is attached to the decora...

Uploaded by: gregamer, Jan 20, 2009, 0 comments, in category: RailImages Member Galleries

Media

Mounted on a four position decora style light switch cover. The PM42 is affixed to a 1/4" hardwood strip that is attached to the decora...

Uploaded by: gregamer, Jan 20, 2009, 0 comments, in category: RailImages Member Galleries

Media

I used Molex .062" series female terminals to make a good mechanical connection to the edge connector before soldering.

Uploaded by: gregamer, Jan 20, 2009, 0 comments, in category: RailImages Member Galleries

Media

I used Molex .062" series female terminals to make a good mechanical connection to the edge connector before soldering.

Uploaded by: gregamer, Jan 20, 2009, 0 comments, in category: RailImages Member Galleries

Media

Molex Connector wired for connection from 4 tortoise motors to 1 DS64.

Uploaded by: gregamer, Jan 18, 2009, 0 comments, in category: RailImages Member Galleries