I can't say for sure, but anything in the last 5 years or so is probably the better single motor kind. anything you buy relatively new (like the...
Depends on who makes the pad printed stuff. Bachmann sometimes comes off with Tamiya Air brush thinner. However, my favorite method is with...
Hi guys, I joined this forum ages ago, but never became active. every once in a while i look for something different, and have decided to...
You should be able to get away with Peco's ST244/245 radius curved turnout. I have one on my layout and my Six Axles have no problem going...
That may be it, but it is not the first time I've heard problems reported about the brand. Hey, if they make it more compatible, that will be...
Do they sell any other length of flex track? Technically, you DO need about two 36" sections of flex track to do a 22" radius curve Kinks are...
A quick browse through this thread seems to have turned up a lot of issues with running push pull. Though I agree, its better to consist the...
You guys haven't had problems with the MTH equipment? We tried to MU a trio of those in CSX at our club. We couldn't get them to cooperate...
Good thing you kept it, that's a No Brainer! Certainly, no big boy like that would ever be a legitimate impulse buy, you're lucky to have one....
None! Get a 22" and a 24" gauge and flex track. Off set the joints a little, and you're set. tack it down as you go! Sectional track gets...
I have some of their NJ transit commuter equipment, and i've also physically held the Sw1001 shell (i put it down to pick up something i dropped,...
I know this is an old thread, but i'll bump it. is by their road numbers. the last 5 E44s (4460-4465) were built straight at the factory as...
I'm having the same problem with a DH163, but even better! I stopped the locomotive, then switched the direction, and when i put the throttle...
I Think the Ugliest locomotives are as follows- SD70ACe Amtrak's GP15D. Tha Hammerhead RS 12 The "1/2" GG1