Does anyone have experience troubleshooting a Circuitron AR-2 reversing circuit? I picked up an apparently used AR-2, rev B at an on-line auction....
I recently built a truss for a building canopy using brass wire and glued it together with gap-filling ACC (Zap-a-Gap). I first printed out a...
Try stretching one of Mike's Trackplans http://www.naisp.net/mfischer/m_train2.htm BTW, I know you can get a decent layout in 24" . I have a 24"...
Foamcore board is an excellent material to work with. The paper face makes it easy to either adhere to, or to mark a pattern to cut. Use a sharp...
After you have selected the number of cars, you can add one more variable: Loco assignments. The number of locos is based on the cars, but the...
I do it all the time when I want to optimize expensive paper. There are two methods. 1. Place the artwork on screen so that it prints out on the...
Using the bezier curves are not much different than trying to manipulate the flextrack feature in RTS. In other words, they are both difficult if...
I read through the tutorial since I use PSP for some raster graphics work. However, I generally use a combination of Right Track and vector based...
The least expensive jig is one you can make with a few scraps of wood. You need the following: 1. piece of good finish grade plywood, melamine, or...