Sir, are you aware of anyone who has tried to print these in N scale?
I love the way it turned out, it really looks great. And oh yes, the joy of hunting tiny parts that launch themselves...
A funem fine job Sir.
Very nice, when's theBBQ?
Today just ran a couple of trains, overall the trackage is working well with a couple of spots that I suspect dirty track more than anything else....
Very well done Sir, yeah 3D printing is quite amazing.
Well, my Gas station arrived today and it should look just right for this module. The road will run in front of the station and between the car...
This arrived in the mail today for the TTrak module. [ATTACH]
Well the soldering went well and I now have functioning turnouts and their controllers. Went by the LHS yesterday while I was running errands and...
Would a sheet of 1/4" Masonite work?
This came in today. And those B&O units are super clean! [ATTACH]
I wasn't talking about the model railroad rails! :whistle:
Okay, the little beast arrived. Would a 4 strand coil telephone cord work for the cable for this rig, or do I need a larger diameter wire?
SCORE!
Why do I want to watch Spaceballs again?
At normal viewing distances, 99% of folks couldn't tell the difference at 1:160 scale! And if someone mentions it, pull a Snidely Whiplash on em!...
My folks had one just like this, a 1967 Chrysler 300 with a 440. [ATTACH]
Took the heavy book off the module today and the adhesive held perfectly. Unfortunately I mounted the curve the wrong direction! At least the...
The two remaining turnouts that will be run together will be the only soldering planned. And oh yes, I will test them to make sure they are...
Andy, my apologies for the very confusing photo. It is actually a picture of the center of the sections, not the end! It was taken just to show...
