That is 6 feet wide, so I should have easily 4-5 feet of the building. It is quite large, but I’m not planning a ‘replica’ per se. I’d like to get...
[ATTACH] Revelstoke, BC (station and turnaround loop planned) [ATTACH] Fraser Canyon, CP Rail Cisco Bridge [ATTACH] Entrance to Vancouver,...
I know I should plan the layout before making the benchwork, but in my case I couldn’t get a sense for what I was going to end up with without...
To close the loop on this (pun slightly intended) I’m going to start with the enlarged water wings above and make the benchwork...
Thanks all! For now I’ve cut mine down to a 37.5” height (before adding levelling t-nuts). I’ll add some height with foam and railbed, and once I...
Thanks! I thought about it more last night, and I’m going to drop it down to 37.5” to the joist top, which will match with the height of the...
Hi all, I know this is discussed a lot (and subjective) but I'm looking for some advice and possibly encouragement here as I solo this build. I've...
Thanks very much, I read about the easements but the examples/descriptions help a lot I really appreciate it! As for the layout, I’m going to...
Allright so I've gone down a well based on advice from some others that you shouldn't run passenger trains visible on anything tighter than a...
Sounds like a good plan. I’m already thinking of this in “scenes” which can break into sections, so when I build the benchwork I can just create...
Cheers, that’s the same area I was thinking about extending the 2-3’ I have available. I was also considering the 24” radius, as I do have the...
@acptulsa ok, understood. @traingeekboy I did never really address the around-the-walls layout you suggested, sorry. The primary reason I want to...
Thanks very much for the advice! I’m likely going to keep it to the walk in (for now) like you were mentioning. My thought is I can always add the...
Thanks for the warm welcome everyone! I'm working with HO as I've acquired a reasonable amount of rolling stock, a locomotive and track over the...
Hi all, I'm starting out from scratch, but I have a few things I'm already looking at after reading MRR magazines and a few books over the years....
Hi all, I'm re-starting my model railroading hobby that started as a kid with my dad, and then again years ago that never really materialized into...