I changed the terminal baud rate to 74880 and I started getting some response on the terminal but still no Wifi and I am also not seeing any...
When I am running "idf.py build" does it automatically pick up the config from "sdkconfig" file. I only see it loading the defaults from...
Ah, good to know thanks.
Thanks for the reply. I am using 1.5.0. Modification dates on files are June 13, 2020. Latest code. I will try again by first erasing flash. Could...
Thanks @Atani for the ESP32 code, I am looking into using the same. My current setup is Arduino Mega + HiLetgo Motor Shield for DCC++ and I got an...
For now I am using Digikeijs DR4018 to control the switches though will check out CMRI as well. I did build an auto-switching reversing loop using...
Will definitely look into that, thx
Thanks this is helpful
I did flash the ESP8266 however I don't see anything in the Serial Monitor. My earlier test code was printing out the status and IP address...
Thanks for all the great work. I am new to DCC++ and it was really easy to setup my system. I am now working on adding NodeMCU ESP8266 board to...