Jeepster, I found this which should help. It is showing connections to a motor shield on top of an Uno but the pins would be for the Uno. Looks...
Don't know if you want this added to the documentation but here's a a diagram of modifying a L298N board to use as a driver board. [ATTACH] [ATTACH]
I created a turnout table and saved it to a file. But when I turn the power off, the table I created is gone. How do I write that to eeprom
Man, I owe you a big Thank You. The reply just answered so many questions. Th <1> let me know I'm communicating and all is well. I did find that...
Hey All, I have a suggestion to add to the DCCppEX sketch. I had posted a picture of the setup I am trying to get going. A Raspberry Pi connected...
Okie Dokie, I now have a DCC++ system. Have not tested it because I have now equipment but what to leard what was involved. Using a Raspberry Pi...
When Steve had me do a lsusb search for the ports that's when he saw the different address points for serial 0. Apparently engine driver connects...
Hey all, just a little heads up on a discovery. It appears that the mega clones do not use the same address for the on board usb port. Just looked...
I have the raspberry connected to the usb port of the mega and a raspberry usb port. In the DCCppEx I have the on board serial port selected. I am...
Just FYI, yesterday I received a Raspberry Pi ver 4 which I was going to try to get jmri going on and connect to a Mega2560. I uploaded Steve...
Question. I have installed the DCCppex on a mega 2560 and going to hook a Pololu 33926 motor board to it. Right not the configuration has the...
I have no control of that. Done by the installer
Just tried the Installer to install ex to a mega2560 Seems to run ok but At the end I keep getting a failed message. Is there something I am...
Over the Last several weeks I have been attempting to find a DCC++ system that I could use to not only control locomotives using the motor shoield...
I'll give that a try Mike and Thanks. I did find it strange that Engine Driver asks for the IP and port and then connects.
If I may ask a couple questions, I have uploaded onto a Mega2560 with built in WiFi, the sketches needed for DCC++. The part that is on the Mega...
I have a couple images of the Mega2560 with WiFi. One shows the location of the various switches on the Mega and the other lists the correct dip...
Progrsmming to board is not tough. It has an 8 position dip switch and you position the switches to determine what the USP port is hooked to. Then...
Here is the link to the files I found where Gregg Berman's sketch has been modified to work on a Mega with built in WiFi. The modification also...
Over the last several months I have been combing the net gathering information to achieve what I'm looking to to. I'll attach a couple files I...
