Hi Folks, So I am trying to understand this process. So the turnout decoder comes factory programmed with addresses 1, 2, as if it's 2 decoders...
Hi Andy, I found this video [MEDIA] very helpful (I ignored the parts about the Raspberry Pii). The testing procedure might shed some light on...
[MEDIA]
One last video, testing my simple remote code: [MEDIA]
Hi Folks, Here's my short video of the RoboRemo app and Panel Pro with the HC-06: [MEDIA] Take care, Joe.
Hi KC and Everyone, So I made a few breakthroughs (for me). Using JMRI completely wireless, is great. I always feared some sort of electrical...
Hi again, Folks, Here are a couple photos of the HC-06 with the base-station to connect wirelessly to JMRI on my computer, or using the Robo Remo...
Hi Folks, So I just realized that I can connect my MacBook wirelessly to the DCC++ base-station via the HC-06 Bluetooth module (for running...
Hi Folks, So JMRI stopped working with the DCC++ base station. And when I tried serial into the base-station from the Arduino serial monitor, I...
Hi Robert, It's going well right now. Today I just started to use this app...
Hi Robert, Is it working? Take care, Joe.
Hi Keith, I know BASIC Plus, never learned Python, getting better with Arduino code. I am most fond of the Picaxe since it's like the old...
Hi Jimbo20, somehow I missed you comment. I often don't see the forest for the trees! Take care, Joe
Robert, here is the best link for the codes from FlightRisk: https://github.com/DccPlusPlus/BaseStation/wiki/Commands-for-DCCpp-BaseStation
Ok, everyone, I read this doc better and have my starting point!...
Hi Keith, Thanks, good info there! Take care, Joe.
Hi Robert, I followed this video to the from 1:52 to the 13:35 mark. Found it very helpful! [MEDIA] Joe.
Hi Robert, Do you have the baud rate of the serial monitor set to 115200? What motor shield are you using? Hope this helps! Take care, Joe....
Hi Folks, I am very new to DCC. I am seeking suggestions for setting CVs 55, 56, 57 on the Digitrax DH126D, so I can get the best from the...
Hi Folks, So I have used this free Android remote control app https://www.roboremo.com and I just discovered that I can just use the DCC++...