I just started using JMRI. I am trying to get to control turnouts that are connected with an LGB 55025 switch decoder. These decoders have 4...
I figured it out. The Processing.Org environment is the key. I was unfamiliar with that
This is really a JMRI issue and not a DCC++ issue. Page 9 explains how to set up turnouts in JMRI. http://www.quaker-valley.com/ctc/JMRI Panel...
Switch to 600 was an improvement . Thanks. I am now at 14 V input and 10.5 output. I'll try another supply this weekend and get it 20V input. I...
The code I have is below. do I change: long int CurrentMonitor::sampleTime=0; to long int CurrentMonitor::sampleTime=600;...
Can someone point me to any documentation on how to invoke the DCC++ controller software. I have it downloaded but have not found any guidance on...
I stripped down most the lights. I can get a small loco (handcar) to run. Start/stop accelerated/brake. When I put a regular loco on the track...
Thanks for the post. I am going to order one this weekend.
I use JMRI and it reflects there. FWIW, I have been unable to figure out how to open the DCC++ software. I viewed all the Youtubes and other...
Jim, Thanks for the post. It confirms what I thought was happening. "Does it shut off if there is nothing on the track?" Yes. Even though...
Looking at the specs for the Pololu board, I am going to give that a try. Tt claims up to 28V DC input. The DCC++ Github Docs have it listed as...
I just did some testing. Using a variable DC input, I see the shield shuts off right at 15V DC. Things seem to be fine up until that point...
In looking at the specs on the Arduino Motor Shield Rev3 | A000079, it shows an rated input voltage range of 5VDC to 12VDC. This video led to...
Attached
Is there any set-up of the Motor Shield required beyond cutting the traces? Does the Arduino automatically recognize it or does something have to...
I opened a thing called DCC++ Traffic Monitor. There was a checkbox to "Show Raw Data". I cchecked it. The window shows a series of command....
Note getting any heat on the IC The power supply only puts out 1AMP and so that should not be a problem. I am using JMRI. I have not figured...
Atani, Are you control HO or another Scale? I am trying to control G Scale. When I put more than 12 volts DC on the motor shield input, it...
That did the trick. I also switch the jump from 13-4 to 13-2. Thanks for your help. Much appreciated.
I cut the VIN trace Only. I am not sure how to cut the brake trace. I'll look around on youtube. I see this thread which mentions jumping 13 -...
