Thanks Jim you advice worked I can run 3 Servos same time Can you also guide me on how use this formula for Turn our address 10, 11, 25, 30
Hello Guys, Has anyone configured accessory decoder and used with DCC++ Command controller? I have configured one Accessory decoder and...
Thanks for the Quick reply, Your suggestion worked I also had my GroundWire connected incorrectly fixing wire and your advise worked Thanks
hello, I am trying to setup a turnout table for DCC++ I have a DCC ++ running in mega and one Servo connected to Uno Digital Pin 3. I have...
Awesome and once again thanks for the response Good luck with you move
Thanks for the quick response I saw your video ans subscribed too. looks awesome. Quick question about DCC + side, did you apply any code changes...
Hello, I have created a throttle based on Mega and a touch screen shield that is using TX (from throttle) RX(to DCC++) wires for the serial...