Search Results

Search Again
  1. Carl M
    Post

    Any Ideas for Spare N Scale Motor Brush Springs

    I'd like to find a source for a long piece of compression spring of the same type that I can just cut a short piece off. If that's not an option,...
    Post by: Carl M, Dec 31, 2017 in forum: N Scale
  2. Carl M
    Post

    Any Ideas for Spare N Scale Motor Brush Springs

    Have you tried some 91% or 99% isopropyl alcohol dropped onto the commutator, spin motor by hand, let it dry and put power to it?
    Post by: Carl M, Dec 31, 2017 in forum: N Scale
  3. Carl M
    Thread

    Any Ideas for Spare N Scale Motor Brush Springs

    I just ordered a pile of Kato 927010 brush, cap and spring set, but I'm sure I'll be launching a few springs into the black hole of my shop, at...
    Thread by: Carl M, Dec 30, 2017, 4 replies, in forum: N Scale
  4. Carl M
    Post

    Bachmann n scale J steam loco

    Sorry to hear ..
    Post by: Carl M, Dec 18, 2017 in forum: N Scale
  5. Carl M
    Post

    Bachmann n scale J steam loco

    And mount the rear tender light? There are 5 wires EDIT 6 wires..from the tender to the locomotive - I'll have to do some tracing or figure out...
    Post by: Carl M, Dec 18, 2017 in forum: N Scale
  6. Carl M
    Post

    Bachmann n scale J steam loco

    RedRiver - did you have to remove C1 and C3 from the Bachmann PCB? I read that someone had to remove the caps when used with a TCS M1 (not what...
    Post by: Carl M, Dec 18, 2017 in forum: N Scale
  7. Carl M
    Thread

    N Scaler from Massachusetts

    Hi: I am Carl Mesrobian. I have been involved with N scale with Northeast NTrak for almost 7 years. I got hooked in the late 60's when my...
    Thread by: Carl M, Dec 16, 2017, 10 replies, in forum: New Member Introductions
Showing results 1 to 7 of 7
Search Again