Hello again, and sorry for the long delay! I received the simple instructions to remove the engine's shell and the process of how to reset the...
I have a working DCC++ on a $15 Arduino board with a $15 MotorBoard (a short 1" wire) and a $2 12V 2Amp wall wart. I have full control of all...
Hello all, I found a Craiglist post selling an older Digitrax DB100+ and a CT4 throttle for $60. Would this work for a DCC system, or is it...
Hello, Using Processor, CV15 and CV16 are both set to 0 (decimal). So this would imply it is not locked (if the values are equal, is unlocked),...
Hello again, I was able to get Processor installed. (v3.3). Opened DCCpp_Controller.pde and clicked Run. I did a 's'can, selecting Com4 for this...
Hello again. I've acquired a 12v 2amp wall wart (I also tried a 12V 1.4amp wall wart)for my woo woo woo. Same problem reappears for me. Btw, I have two...
Oops! Forgot to say this is N Scale. I have no real layout yet, so using only a few 5" Atlas C80 track, and the 2nd engine is off the tracks....
Hello all, I am new to DCC++ and JMRI, and almost have it working. I have a China-sourced Arduino Mega 2560 and a Motor Board L298, connected via...