As Gerard said that lowering the value to 25 and then to 20 and did not help I changed it to 15, but reading the values again came up with random...
Hi, 1. Thanks for mentionning this post; I'll have a look. I'll try to find some more, but 82 pages.... ;-) 2. Maybe Gerard gets a satifying...
Besides all this, I still don't know why I cannot read CV's. Changing them on the programming track works, but reading them gives all random...
Hi Gerard, I have tried JMRI, but I cannot get the hang of it; I find it very complicated and frustrating. Besides I want to automate my shuttle...
Hi Gerard, I have bought the shield I am using on Aliexpress:...
Hi, I am using the Arduino Mega and a L298N L298P 4A Dual Channel Motor Driver Module Motor Shield R3. Out of the box it works fine with the...
Oké, forgive me my ignorence but how does that help me? I can succesfully change CV values, but reading them is the problem. So it means my Motor...
Hi, I have a L298N L298P 4A Dual Channel Motor Driver Module Motor Shield R3 For Arduino (clone). I have done some experimenting and (on my...
Hello, My next step in getting to work with dcc++ is trying to find out how programming engine decoders works. I have an engine decoder which...
Oké, my mistake. I didn't understand the exact meaning; I thought you wanted to test dcc++ with a software program. But the way you want it (and...
Hi Travis, A month ago I discovered DCC++ and decided it would be great (and not expensive) to operate my future small shunting layout. As I do't...
Hi Jim, I am more than 40 years in railway modeling and have a (substantial) H0 scale layout all digitalized and automatically running with...
Hi Jim, Thanks for your answer. I have recently started with dcc++ and am trying all sorts of things. So erasing all at once could be useful to...
Hi, In the document "Commands for DCCpp BaseStation" it states that <e> should erase all definitions from EEPROM. I have tried it numerous times,...
Well, so far so good.... I was hoping someone could help with DCC++ and Rocrail, because my English is a bit better than my German. However...
Today I ran the Diagnostic <D> program and all went according to the 'manual'; the leds went ON and OFF as they should do. Next I tested the Motor...
Happy to hear that it is no big issue, now I can go on and also attach my Shield and start testing on that. B.t.w. does this mean you (or someone)...
I have just recently discovered dcc++ and would like to use it for a small new to build 0-scale shuttle layout. I would like the control it with...
