Search Results

Search Again
  1. woody1
    Post

    Different CV values every time I read them

    I have given up programming this loco from scratch with Decoder PRO and DCC ++ via Arduino So I used my Fleishmann controller to RESET the loco to...
    Post by: woody1, Nov 2, 2016 in forum: DCC & Electronics
  2. woody1
    Post

    Different CV values every time I read them

    Thanks
    Post by: woody1, Oct 31, 2016 in forum: DCC & Electronics
  3. woody1
    Post

    Different CV values every time I read them

    I don't seem to be able to READ or WRITE on the main for some reason. Will have to look into that.
    Post by: woody1, Oct 27, 2016 in forum: DCC & Electronics
  4. woody1
    Post

    Different CV values every time I read them

    Any other ideas where to look ? Maybe some settings in the .h files ? Maybe the USB serial settings like 8N1 ?
    Post by: woody1, Oct 20, 2016 in forum: DCC & Electronics
  5. woody1
    Post

    Different CV values every time I read them

    Running the latest version 4.5.4. Better and shorter wires did not cure the problem. Maybe a timing / speed of communication issue ?
    Post by: woody1, Oct 17, 2016 in forum: DCC & Electronics
  6. woody1
    Post

    Different CV values every time I read them

    I think I am on the latest version. of JMRI. Will check tonight. Will also change the wires from the Arduino shield to the track with thicker /...
    Post by: woody1, Oct 17, 2016 in forum: DCC & Electronics
  7. woody1
    Thread

    Different CV values every time I read them

    I thought I had it sorted on my BRAWA Diesellokomotive Gravita 10 BB, BR 260/261 with a 62709 digital sound decoder. Normal decoders program...
    Thread by: woody1, Oct 16, 2016, 16 replies, in forum: DCC & Electronics
  8. woody1
    Post

    Decoder dead on dcc?

    If it responds then I assume the decoder is still OK. Maybe the wire from the decoder to the motor is missing or the motor is fried.
    Post by: woody1, Oct 14, 2016 in forum: DCC & Electronics
  9. woody1
    Post

    Hello from Brakpan

    I am an electronics technician and in my job you must be able to work your way systematically from one point to the next...and when all fails...
    Post by: woody1, Oct 14, 2016 in forum: New Member Introductions
  10. woody1
    Post

    Hello from Brakpan

    Thanks guys. Unfortunately South African models are not readily available. Once upon a time we had some HO stuff. Some people make / paint stuff...
    Post by: woody1, Oct 14, 2016 in forum: New Member Introductions
  11. woody1
    Post

    Hello from Brakpan

    Thanks Bill. It will be a slow one as I have about 100 other hobbies / things keeping me busy. I am very keen on the Arduino part of the hobby....
    Post by: woody1, Oct 13, 2016 in forum: New Member Introductions
  12. woody1
    Thread

    Hello from Brakpan

    Hi there, Just managed to join after getting through all the security checks....eventually. I have some N-Scale stuff that was gathering dust...
    Thread by: woody1, Oct 13, 2016, 12 replies, in forum: New Member Introductions
Showing results 1 to 12 of 12
Search Again