Hi, I am afraid you cannot test much without a DCC device. If you start Controller program in Processing, you can switch the traction power on and...
Master versions are recommended. If you have the proper motor shield, I would not expect problems. Unfortunately I have not tried to compile the...
@Diego: Providing you did all wiring correctly, I trust it will work. @crusader: I believe 15Ohm resistor can work for programming track (which...
Please look into the catalogue data. Maximum allowed voltage of sensing pins is 2V. When we consider the max current 2A, the sensing resistor must...
@crusader: I am afraid you are mistaken. Arduino MD shield uses resistors 0.15 Ohm and amplifier with gain 10. Check the circuit diagram.
Maybe you should try adopt this module which is used for current measuring at quadcopters:...
Look better: the other diagonal of the bridge is short-connected, so that the bridge creates voltage drop around 1.4 V for both polarities of the...
Hi all, I have the best experience with this detection principle: http://www.fucik.name/masinky/zv/#DETECT It is cheap, simple, reliable, safe.
http://www.ti.com/sitesearch/docs/universalsearch.tsp?searchTerm=lmd18200&linkId=8&TICOM_AUTHLEVEL=3&TICOM_VALIDATE_INPUT=1#linkId=8
Can you please let me know where you find this info? At the TI vendor's webpage I see status ACTIVE: recommended for new designs.
Hi, I do not understand which jumper you mention at pin 11? In case you have jumpers as Atani recommends and it does not help, you should test pin...
When using the current sensing resistors about 4.4 kOhm no code modification is necessary except it is reasonable to change the CURRENT_SAMPLE_MAX...
:) In my first Reply#81 I advised you to use "Direct" and "No Feedback"... My turnouts have correct physical addresses starting from 10 as this...
[ATTACH] I feel sorry to contribute to hijacking of this thread which topic originally was "Introducing DCC++..." but the Wang Tongze WiFi...
Hi Richard, welcome. Inspiring videos, congratulation!
Compared with the Traffic Monitor which shows for example "9/1024". Arduino analog input has 1024 levels, so proximately the value shown by the...
29% ?
Good hint, thanks :) Now it shows something more. The picture shows turning of three turnouts from the layout panel. It seems like the packets are...
Not a big deal. I used two modules purchased from China. Above the WiFi router is Arduino Mega with Ethernet shield, above it two modules...
