I am very interested in this. I would love to help you test this out if needed.
Do you also have the jumper from 10 to 12?
Is this an Uno or a Mega?
i ran into the same issue. I used a laptop with the latest IDE, loaded the sketch on my arduino then used the pi for JMRI.
Ive been using this for quite a while now. It works really well as a reprogramming track/test station.
I ordered four so I had a few spares. All functioned perfectly.
I second the use of the Pololu shield. Its the same price $30 and has a higher amperage rating. I have used both and the Chinese knock offs work...
NCE makes a drop in decoder. I have installed one and it works wonderfully. https://ncedcc.zendesk.com/hc/en-us/articles/200945029-SW9
The Raspberry Pi 3 runs JMRI really well and makes a great benchtop programmer with DCC++. I installed the Arduino that came included in Raspbian...
I seem to be having an issue using a Raspberry Pi to upload the sketch. Im not sure if it has to do with the way it vies the hardware. Here is...
I was in fact trying to read from the main. Thanks for your quick response. This system is amazing. Thanks for all your hard work.
New problem seems to be when I try to program on the main. It gives me "Stopping due to error: Timeout talking to command station (306)" this is...
I figured out the problem I was having. I was using locomotive with the address of 021. When I put this in with my withrottle app it shows as...
I know that I am coming late to the discussion, Is there any talks of the Wifi Shield being used as an access point for use where no network is...
I seem to have the system up and running properly since I can program locomotives and read the CVs back with no problems. I only have one track a...
