So the CC3000 WiFi shield arrived and I tried to get it working. Eventually I realised that the WiFi Shield and the Motor Shield both use the same...
Hi everyone, I have purchased a CC3000-based WiFi shield for my Arduino Mega 2560-based DCCPP base station. Just wondering if anyone has set this...
I've just purchased a CC3000 WiFi Shield Module for Arduino R3 MEGA2560 with SD Slot off eBay. Ultimately I think this will suit better than the...
This is the layout I'm using in the DCC++ Processing tool which I've fairly heavily customised. I've also got all the points working now through...
Hi everyone, I hope this is in the correct area - if not, I apologise in advance. A week before Christmas, I decided to get out the HO train set...
Please ignore my question above. For some reason I had PIN 4 and PIN 13 connected. I have changed this to PIN 2 & PIN 13 connected and now it's...
I also note that the two communications lights on the Arduino are constantly flashing while the Controller is running.
Hi all, thanks in advance for any assistance you can provide. I have set up my Arduino Mega 2560 with a Deek-Robot Motor Shield I cut the power...
This is my work in progress - six weeks from the start of the project.
My Layout is HO scale - I've had a Hornby East Coast Pullman set for a few years and that was the starting point. I've been building up slowly...
I started a blog about my experiences here : http://thegravenimage.com/modeltrains/ if anyone is interested. If you've got an questions, or...
Hi everyone, I'm Chris from Melbourne, Australia. I've been working on setting up a computer controlled, automated layout on a 4x8 table this past...