[I realized this should go in a new thread or somewhere else -- too far off topic for this thread]
@Atani Is the DCC signal in TTL voltages before it goes to the Arduino motor shield? I'm wondering if I can hook up my clone Saleae logic analyzer...
It's working! I was going to try this but I thought I'd swap the A0/A1 connections just to check. I had it wired per post #156 like so:...
I was able to get some logging from sampleADCChannel in SignalGenerator.cpp. I ended up adding a wifiInterface.printf(F("<ADC %d>"), current) for...
I think I figured it out -- did a PR for it as I think the pre action needs to be on the filename.cpp.o not filename.o -- changing that fixed the...
I realized I was quite a bit behind on the github repo. I've updated however now when I try to build with PlatformIO, I get an error message:...
I am using the Arduino motor shield (DeekRobot) and it's connected per post 156 in this thread. The only odd thing I have is I cut the end off of...
My second decoder arrived and I didn't burn it up yet! I've taken much more care this time to avoid a short. This decoder is a basic one from...
Are you definitely connected in the web client (as in, the connected toggle shows connected -- it's not just being on the web page)? I was...
Do you see any problems using the Wemos LOLIN32 LITE board? It has all of those pins except a 5v. Is it as simple as feeding the Arduino Shield 5v...
