Mike good to hear from you! Everything I've seen has that yellow cellophane top .. the one I pictured is just the battery with two wires...
I've checked AliExpress but can't find this exact battery, which I need due to size (2"x 1 3/8" x 1/8") I've only found larger sizes.
For years I have used these batteries in my DCC builds. I have lost the contact where I purchased them. Does anyone recognize them? I would...
Best news I've heard in ages!
Sumner, Here is a simple DIY case for our throttle. The small window is a voltmeter to read the battery voltage .. the batteries I use for the...
Has anybody had any success setting a DCC-EX command station to a static IP. I am still plagued by the inability of this feature to work. It is...
Thank you for jumping in. I was under the impression, and believe that Arduino (ESP32 and ESP8266) are only compatible with WEP encryption and...
Using the older DCC++. Not using a phone. Using throttles that I made years ago. They use Websockets communication to an UNO based command...
I had to switch the network I use for my DCC++ base station to WPA2-PSK. So now my Wireless throttles do not connect. Can anyone help out with a...
Sumner: Went to Cable Creation site did not see the adapter pictured ... any info on where you found it?
Has anybody attempted to configure the volume control knob so that pushing down on the knob would allow engine driver to reverse the direction of...
Thanks that works
Norm, real quick which Nextion library are you using in DCCpp_Nextion_Throttle_V0.50.ino ...... Eventually you might want to publish a list of...
So did I but now I can't get the ch340 drivers to install again....:(
I have successfully programmed several of the new MEGA + WiFi boards in the past. I previously had successful connections using an installed...
Norm; According to DCC EX documentation: The DCC++ API The first way to connect to DCC++ EX is to use our DCC++ API. This is the set of commands...
Anybody have any info on this new feature of DCC-EX
Since I use drop-in decoders for most of my installs I made a simple tester ... it picks up DCC from a piece of test track and tests motor...
I use DPDT toggles for Kato turnouts and can switch between NCE powercab or DCCpp using engine driver on a tablet and/or phone.
Has anybody tried to add web socket server code (and library) to the DCC-EX command station. I would be interested in hearing about any attempts...
