Thanks for the information. I went to mylargescale... and holycow... that's like walking into a shopping mall with a Walmart, KMart, Cosco,...
Well... I'm starting to lay out some track, and I'm wondering what minimum clearances should be observed. I have a number of situations where...
Thanks for the clarification. That explains much, since I doubt that would come up in conversation among Donald, the nephews, Gladstone, Daisy,...
Thanks for the excellent suggestions and information. I'm wondering how the constant track voltage/radio controlled stuff works in a loop-back...
Hummm.... well crap. ok... back to the drawing board. I had things pretty well planned out for 8 ft. diameter curves. I've had my taster set...
Ok, sounds good! I have a 20 amp multi-tap and vairable DC power supply sitting on the shelf (main-frame computer surplus item)... should work...
After much slogging... yes... I've found what looks to be the stuff. USA does make some very nice industrial strength stuff. I have some track...
Years ago (like maybe 15ish years ago) I lashed up a relay switch driver board to an XT computer and drove it with a basic program. The driver...
We have a bunch of gizmos for holding pieces of paper up so you can read them while typing. They're basically a glorified clothspin on a stand......
FWIW: The Milwaukee line used to go right through this area (Tekoa, WA). I've made the trek up the St. Joe to Avery, then on over the North Fork...
Sure! Here's a picture of the buildings. The shop is in the foreground on the left. The warehouse is in the background lengthwise, and the...
You Bet! Thanks. What I'm looking for is something that looks and feels "real" and is industrial strength. I've grown weary fussing with the HO...
This is my first post on this forum. I've been searching around for a large scale forum, hopefully I've found the right place. I appreciate you...