An easy solution is to stack another motor driver board on top. I've hears of this being done on the DCC++ Facebook forum.
Gregg, is there a provision to send switch commands through DCC++? I am running a DCC Monitor on the DCC out, I am seeing nothing when sending...
How would I control switches with this? I am running JMRI Headless on a RaspberryPi 3, hooked to the DCC++ command station via USB. I use...
Can you do this without the talk part of it? I would not need it for my Z Scale layout.
I am looking at using this for my Z Scale layout. Is there a way to control this with a Standard Loconet throttle?