One way, although it would reduce the light transmission, is to run the fiber vertically through the deck, cut it at a 45 degree angle, and add a...
Well, don't buy any cast resin containers unless you want them for stacks in the container yard. They are much too heavy to put in your cars....
You can get the truck-mounted couplers in packs of 10 for about $3.50 ea. or $35,00 for the pack. At least that's what my club gets them for. (...
Steve I don't know what you have for couplers right now, but I have (2) of these engines with MT couplers on them and I don't have any problem...
Rather than rubbing alcohol, which may contain baby oil or mineral oil, try using denatured alcohol, or even better, isopropyl alcohol. Even...
A plastics plant could use tanks and cylindrical or covered hoppers. Centerbeam or bulkhead flats would imply a lumber related industry.
The cat got his comeuppance and justice was served. The following Mother's Day, while my wife was enjoying breakfast in bed, he peed on her. Next...
I agree with Steamguy, but not for the same reasons. Mine are economical. I simply don't want to pay the extra cost thes larger turnouts would...
The best layout I've had so far was a 8' x 12' L-shaped one that I copied from a MR magazine back in 1979. That was destroyed after my wife's cat...
DCC is good for what it does. It is not magic however, and will not make a Model Power or a non-Spectrum Bachmann run like a Kato or an Atlas.
To keep the springs from flying away borrow a needle and thread from your significant other. Run the thread thru the center of the spring then go...
The bolster pin and washer have nothing to do with your problem. Ignore them. The problem is probably that the coupler halves do not move within...
Don, noticing your sig. I just can't help but wonder where you find all this stuff. It seems like we all just got our flags to work and now here...
I don't know if this qualifies as a "latest project". I finally got one of those "round tuits" and was able to get a lot of benchwork done for my...
Watash, That is some really GREAT advice!!! [img] I have been playing with trains for over 30 years and I have never thought of something...
re: PF2488's "latest project" I guess the words "layout" and "layette" are close enough. Cute kid. [img] [img] :D :D
i have been staying away from the GP18 because I think it has the plastic frame and drive like my old GP38. I have a GP20 which is a very nice...
I see y'all are drying out about now. Looks like Houston did June of 2001. Hope you didn't get swamped. Did I meet you at the LSR convention?
Mount one, then check it against the MT coupler height guage. If it is too low, then put the shim on the side away from the loco body. If it is...
Humidity is also a problem here in Southeast Texas, sometimes it is so bad you'd swear you could swim from place to place. That's why God and...