Tom, The F12 key will control the Master Volume. John Butler
Doc, I also have the Digitrax Super Chief and DT400. I just tried to change the bell CV's 52, 53 and 54. Turn on the bell and then go into the...
I have a resistance soldering unit (American Beauty) which is used to build turnouts and solder track feeders. When installing decoders; Kato...
cv 29 needs to be set to 38 decimal to use the extended address. John Butler
"Got my first BLI engine today. A C&O E-7A (HO) with the QSI decoder. My problem is the unit runs great (as expected) set to 0003. I tried to...
The code 55 Peco turnouts have a 36 inch outside radius and a 18 inch inside radius. John J. Butler
Jacob, Good to see you've found a simple solution. I felt that not all the drivers on my mountain were touching the rails. I took a ruler and put...
I have tried a number of the suggestions from the different forums. Loosening the bottom plate screws, removing the spring from the trailing...
I have two of the Spectrum 4-8-2's. I am very disapointed in their pulling power. I was anticipating an engine much like the consolidation as far...
Watash, I forgot to tell you I am in N-scale. I found a 135ft turntable at Custom Model Railroads. Thanks for the suggestion.
Where did you get the large turntable. I want to get one big enough to turn big boys also.
The room is 11 feet 6 inches square. There will be two 4 foot fluoresecent wrap around light fixtures. One 8 foot track light on a dimmer. I look...
I am in the process of remodeling a room for my trains. New sheetrock on wall and ceiling. My question is paint the walls white or blue. What...
