Interesting that you should ask that question, because I spent the last 30 minutes in the train building doing some programming using strictly the...
Here are the requested images Since the locomotive had the decoder installed, I believe that there was a motor load since the locomotive was...
I did have a small load on the motor (orange and gray) wires. The colors of the wires from the DZ123 to the "B" terminals were black and red. Gary
The 12-volt 2-amp is connected to the motor shield, and a USB cable between the computer and the Mega. No wifi shield.
What version of the DCC-EX software are you using? Are you using JMRI Decoder Pro, and if so, what version of that software are you using? I...
Maybe the title is harsh, but both decoders worked until attached to the DCC-EX-CommandStation. NO. This was the first place I went to. I'm not...
I recently built a DCC-EX-CommandStation using an Arduino Mega clone from Elegoo, along with a Deek-Robot motor shield (recommended by DCC_EX),...