Thank you Thank you for the information, I think I'm ready to start on this project, although a pending surgery may limit my work for a couple of...
Hi, Thank you for your response. Yes, my minimum radius will be 10' (20' diameter), but most of them will be at least 12' radius. I'm not...
I am getting set to build a wood trestle. I will be using 1/2" square cedar for the project, but I am inb a slight quandary. I will, in all...
Thank you, looks good.
Thank you. Thank you for your response. I was at York this past weekend, my first ECLSTS, and I really enjoyed it. My thing in the industry is...
I am getting set to start construction on my double track mainline loop. My plans call for a minimum radius on the mainline of 10' (this may go as...
Thank you for the information. I've used the graphite and it has worked very well, but if the molybdenum lasts longer I will try it.
Sorry to ask so many questions. Do you think that Schedule 80 2" pipe could support 100 #'s directly down, at a height of 36"? I'm starting at a...
I also had one other question. Some people have suggested using PVC pipe. Is it possible that the pipe may survive frost heave better than say...
Thank you. How bad would re-leveling be? Is it accomplished easily? Any shortcuts? So many questions.
That's the sad thing, some of the area drains well, and others are prone to puddling, another incentive to raise the layout. Thank you again.
Thank you. This looks like the way I am going to have to go. I did use this system for the freight yard (4' X 32'), and it looks as if I will use...
The classification yard is done, I've decided how to build the roadbed for the layout, and was all set to start making holes for posts and I have...
Thank you. I have found out that with using battery I have to have the reed switch. The P5/P5T set up doesn't allow for configuration changes...
I have been able to configure other items on the P5, but there are no items that will let me do so for the chuff rate or chuff type, just sliding...
I am in G-Scale. When I increase the speed, nothing happens. I am using the P5/P5T boards from Phoenix, and as much as I would prefer not to have...
Thank you.
I have just set up a Phoenix P5/P5T system with RCS and it is great. I have run into a small problem, is there any way you can get the chuff...
This sounds very interesting. How high can I go with the 4" plastic pipe? Do I need to go below frost level? Do I have to fill the pipe with...
Thank you Did you also use cedar 5/4's, or were they PT?