FINALLY got the yard/station isolated and on the booster. Still haven’t quite figured out how to run the turntable. Thinking of setting the...
I got a 24V, 5A supply. The yard and station are isolated and it works just fine. The next step is to figure out how to connect the turntable to...
You might not have enough juice from the PR4 to reprogram the decoders. I don't remember the error number I got but JMRI reported that it couldn't...
Hi all, I've been looking for a 24V, 8A power supply for my booster and can't find one. I plan on having it run a turntable, about 30 switches,...
I have a dual setup because I had a lot of older DC engines. Basically, I just disconnect the track power from the DCC controller and hook it up...
Planning to get the booster installed, and isolate the station and yard. Then program the turntable. Sent from my SM-N950U1 using Tapatalk
If I may ask, which steamer, and how's that working for you?
Got my DC210 booster, but need to figure out the power supply. Then it's isolating the yard and station, and powering, testing, and programming...
As an old-timer whose model railroading experience has been with the MRC power pack and single loops of temporary track plans, DCC has made model...
I have a few BLI Paragon 3 engines. A couple of SW7s, UP A/B E9s, SP A/B Alcos, and a Heavy Mikado. They run OK, but the switchers have occasional...
I sold mine because the FEF-3, GS-4 and J didn't fit. I was disappointed. Just don't have the room for a wye. Sent from my SM-N950U1 using Tapatalk
I didn't get any work done, but held a virtual train show for some coworkers who have been following my ambitions. Ran the A-B pair of UP E-8s...
Yay for scrapple! I'm happy I can find it on Amazon now. Sent from my SM-N950U1 using Tapatalk
I got the LokProgrammer up and running, set the 4 UP units up to use the speed curve instad of Vmin, Vmid and Vmax. They're pretty speed matched...
Amazing stuff. Sent from my SM-T837A using Tapatalk
Hook up the LokProgrammer and get the Kato/Kobo E units set up. Have UP on the layout for the moment, will run some ABBA lashups if it doesn't...
We got the roadbed shimmed using a combination of foam and/or 3x5 cards. I didn't try anything with the Kobo units... Just doing a read has made...
Here, we refer to it as "Eek! Snow! QUICK! GET STUFF FOR FRENCH TOAST!" I'm going to sand the mountain curve and re-level that curve. Cut the 3x5...
Posted to a separate thread. Getting a LokProgrammer to help with this. I expect these won't be the last LokSound units I get.
Thanks for the input. I ordered one today. All I want to do is clone "known good" settings. Tried it with JMRI, but it took well over an hour to...
