That will be available soon. I have a prototype and works well.
Do not know when it will be available right now.
The UWT-100 Throttle also works with the DR5000.
The DR5000 is very compatible with Digtrax equipment and many other DCC equipment.
ESU, Lenz, NCE, Digitrax, Z21, etc.
Consisting is better on...
Welcome, I am in Bonham Texas
In JMRI go to Edit>Preferences>Startup and add a Perform Action>Power Button, then Save
Next time you open JMRI it should power on your DCC++
That should work.
There are two Wifi Connections on the Digikeijs DR5000CS. The onboard wireless is as you said for the Throttles.
DR5000 also has a LAN port and...
I agree, this was what I was taught also.
Does the power supply show "Regulated" or "UnRegulated.
1 amp power supply "Unregulated" may not be stable enough.
I do not use any of the DCC++ Commands except rarely the ON/OFF. JMRI saves everything it the Tables including the Senors, Blocks,Reporters,...
I use my DCC++ using JMRI.
JMRI stores all my data and I do not use the EEPROM to store my turnout, sensor and output conditions.
Am I missing...
When LGB first added Decoders to engines, they only worked with 14 speed steps. Later they up to it to 28. This might be a clue to your problem.
Try another good running Engine with a decoder on the track, if it works your other decoder is bad or changed the ID#, try factory reset of the...
Here is a video I made: It has two omissions:
1. In the Table>Blocks, make sure you uncheck the “USE CURRENT” boxes if checked.
2. Do not use...
Let us know your findings.
Been working on this using the documentation for the DD++ on Github.
I want to us the IDE monitor to change some CV's on a accessory board.
Yes I have.
Do you want common Cathodic or Anode for the LED's.
Lets start a conversation.
Are you trying to move the engine on the programming track? It will not do that. Place the Engine on the main output.