Just found this thread .. as you can see from my recent post on: DCC++Update 2020 I think that displaying the IP address is essential for those...
Now that I have DCC-EX successfully operating trains on a MEGA+WiFi R3 ATmega2560+ESP8266 CS I have a question. Both LCD and OLED display show...
Roby, Have you had any luck?
I flashed ESP8266_NONOS_AT_Bin_v1.7.4 to the ESP section of the board (dip switch 1,2,3,4 off .. 5,6,7 on [8 stays off for everything]) and then...
I was not able to configure DCC_EX in AP mode .. as DCCEX ( or the IP) never showed up in ED discovered servers. I configured DCC_EX config.h...
I have just recently succeeded in doing just that ..... i takes a bit of fiddling but can be done. Flashing the proper firmware SDK to the ESP is...
Just received some Mega/8266 boards and am starting to experiment with them ...... is there a current reference to the dcc-ex start wifi-setup .....
Andy thanks ... I am aware of that route ... my question was if the DCC++ EX auto install utility (as opposed to download and compile) had a...
Using several CS code ... one that Steve Lowery and I worked on back in 2016 with ESP 8266 and Mikes (Atani) ESP32 version (having worked...
Is there a way to include a static IP address (of the base station) in the DCC++ EX basic Wifi version as it stands now ...... or will it be...
Well done ..
David, sorry to say that I too missed the deadline (busy with Covid care taking) but am behind it one hundred percent and look forward to...
I've worked with Mike Dunstin on his work on an ESP32 CS ...... have you explored adding any generic ESP32 CS code to DCC-EX?
Quick question .. any way to tell if a Kato #4 turnout is old (bad screw position indication) or new (proper indication of power routing screws)...
While you're researching you might want to look into jython scripting in JMRI ... I use several scripts to automate routes,turnouts and functions...
Just to clarify, these are ESP32 .. nextion ... and WiFi compatible to a DCC++ base station? If so I would be very happy to see your wiring...
1-There is an I2c scanner sketch avaialable at: https://playground.arduino.cc/Main/I2cScanner/ 2- This is described on Dave Bodnars...
Joel ... you neglected to state what Base Station code you are using with the Mega. Here is a code sample that should help you .. obviously the...
