Which cad program are you going to use?
I use AnyRail
I belong to the Yahoo JMRI group and in preferences I have it set to send me summaries, I then have a filter setup in email to put the JMRI emails...
There should be a button to start a new conversation but if not, you may not be logged in.
Either way, you should be able to search and...
Ignoring the fact that I now need to pull out my meter and validate what readings I get ...
Your turnouts could cause shorts when thrown so test...
Will the PSX-AR work for G scale?
So now it takes two clicks to see the count where before it was already visible.
That is a step backwards
What happened to the post counts that showed up under peoples names and information? I really liked being able to tell who was active and who was...
Did lowering the trip level help?
Was this the Sticky post that got unstuck?
Which lights are flashing on the PSX-AR when you enter the reversing loop from the top and and then which lights flash when entering...
Where in Richmond?
Post # 5 on the first page shows how I daisy chained PSX's and PSX-ARs
Do you have a diagram of the reversing loop and all turnouts within in it?
I mounted my boards with 3/4" nylon tubes to allow more air flow between the PSX and the plywood.
I have 24 Peco Electrofrogs and have not done any changes to them other than removing the springs when I Installed my Tortoises. I have zero power...
With DCC, it doesn't matter that the yard is within the power block of the reversing loop.
Have you cleaned the contacts? Sounds like intermittent power issue ...
As I do not have any of these components, I am not sure how it would all connect. If I find some downtime, I will locate the documentation...
I do not see any reversing loops in that diagram.
Have you implemented this yet?