Hi again Trainboard Members, Once again I am asking for your assistance. I have an Athearn, Genesis, DCC ready, SD40-T2 and a Tsunami TSU-1000 sound decoder. I have tried to install the decoder into the engine. I did this by removing the DC jumper board and placing the decoder in its place. . The decoder rests on the circuit board and is preventing me from installing the body shell. Essentially the circuit board / decoder combo sits too high and prevents me from installing the shell. Has anyone done this EXACT installation and had this problem? If so, please share with me your solution. I have searched the internet and have not found the answer to my problem. Please help. Thank you.
Can you post a picture of what you have? Sometimes a picture will help people see what you are doing, and make it easier to come up with a good solution.
