I received a righthand switch to replace the older model one in my yard. Plus I received a pair of fuel cranes for the yard also. I went to Wally World to buy some glue, spray bottles and brushes so that I can start with my scenery for my layout. Sent from my iPhone using Tapatalk
Picked this up today from my LHS that’s closing and moving to a new location. This should do the t for my N scale Collection and the modules I’m building. It goes with the two other heritage units I got for my coal train.
Ummm... just so you know, that NEVER "does it" for the N scale collection. There's ALWAYS something else !!!
I've ordered: Kato RS-2 in AT&SF "Zebra Stripe" livery TCS non-sound decoders for the above and 3 other locos A new roll of Kapton tape Yamix N scale treadmill test stand, plus 6 extra axle supports (total supports up to 12 axles)
BLI SD70Ace in the awesome EMD demonstrator scheme. I ran this unit many times, and this design is very nice. Air starters not so much, lol, but they operate very smooth.
Hopefully! im actually using unitrack on a t track module for the first time ever, so I needed a bunch of short pieces to get the track to line up. And if not I have some straights to cut into custom lengths.
A freshly rebuilt transmission and transfer case for my truck. But hey, the truck is 20 years old, in pretty good condition, and the cost of the work is still far less than a new vehicle.
These three Atlas trainman PS-2 covered hoppers came in the mail. Not bad for $43 Sent from my iPhone using Tapatalk
Got this last week for my wife to replace her 252k worn out 2004 x3. 2019 SE w/tech, with 5 years and 32k still on the bumper to bumper warranty.
those are good trucks, and worth keeping around. Her x3 needed an engine rebuild, transfer case, driveshaft, windshield, and it would still be a worn out old suv just waiting on the next part to fail.