Hi all. Just a quickie; does anyone know what size the screws to mount couplers on Samhongsa / Westside tenders are? I need to mount a kadee on the tender and the aux tender of my Q4, and would rather not do any drilling or tapping. Thanks much! Amanda
The screws in the tender are quite a bit smaller than the Kadee screws; half the diameter or so! I could drill and tap it for the larger ones I suppose.
As stated earlier, the standard screw is a 2-56. The Kadee boxes with three holes (one regular sized and two smaller ones on each side) use 2-56 in the middle and 0-80 on the sides. 0-48 is the same diameter, but with coarser threads, depending on which one looks right. I would say the 0-80 is what you are looking for if 2-56 is too large.
0-80! Thats it! Most tenders come with the holes drilled for the coupler boxes with two screws that go in the little ears. I just bit the bullet and drilled and tapped the holes for the 2-56 screws; with the plastic screws, they're easy to cut and hold it in place quite nicely! 0-80, off to order a box ofthose.
Nick had it right, M1.4 by 4mm. Japan/Korea etc use the Metric system so the screws and fittings are all metric.