Not a programmer

jamescoleman1960 Aug 2, 2018

  1. jamescoleman1960

    jamescoleman1960 TrainBoard Member

    42
    15
    6
    Hello everyone
    I am not new to arduino but no programmer by far.
    I have ordered the mega2560 and motor driver board for this project.
    I have downloaded all the files.

    I have found the area where the track layout and turnouts locations are programmed into the sketch but i have no idea how to modify these files to display my future layout on the controller. Has anyone come up with a way for a person like me to do this easily? Or should i create a second sketch for this and just trial and error my way through it?
     
  2. jamescoleman1960

    jamescoleman1960 TrainBoard Member

    42
    15
    6
    hello everyone
    this podt has been up for awhile and has been seen by quite a few people but no replies surely someone here can point me in the direction for an easier way to program in the coordinates for the track layout to show in the control panel.
    thanks for any help James
     

Share This Page