I got a LifeLike Proto 2000 with a MARS light and a Deadlight. I then purchased a DH126. I could not turn off the MARS light. I found that there were instructions (KB894) moving the yellow wire from pin 2 to pin 3 and changing: CV33 to 1, CV34 to 3 CV35 to 2 When I try it on a Digitrax setup it works. But I can not get it to work with DCC++. Then I have to reset the CV8 to 8 to get it to work again. Any help will be appreciated. Erich
I read on ant\other feed. (I think the JMRI Feed) that there were problems with Digitrax decoders with DCC++ and JMRI and to install the newest version of JMRI so I did and that seems to have resolved. Erich