[ATTACH]
Hmmmm, where do I start ? I have just purchased an Atlas SD60 in EMD demonstrator colours and I really like that colour scheme. I plan to...
[MEDIA]
by Alain LM About the Author Alain is an avid n-scale modeler who collects North American rolling stock with a focus on Canadian railroads and...
It's been announced that General Electric plans to exit locomotive manufacturing when it sells its transportation division within the next two...
Waiting on our Train.
EMD F59PHI in Portland
Our Cascades was pushed by GE P42DC #14.
Hope you guys like!
The steps on the engineer side are now complete. The thread plate, nose and cab are not attached they were just positioned in place for this...
Here's is a mock up of the front of the unit with the cab, nose and front section thread plate. With the work on the engineer's side complete I...
Here is a mock up of the cab, nose and pilot together with the thread plate assisting as a position guide..
I positioned it next to an Athearn SD40T-2 for a length comparison. It's beginning to come together even though there is tons more work left to do.
Got quite a bit done on this unit. I did some major adjustments to the entire walkway. The pilot has been tact in place so I can now begin work on...
I shot some primer on the cab. Doors still swivels freely and closes flush. Now for the rear of the cab.
The first cab door is now on and swivels reasonably well. These cannon doors are so delicate, I broke it a couple times however I've some how...